Recent Changes - Search:


Taig Mill

Duet3 Control


edit SideBar


I've been using this post-processor for about a year very successfully with the Taig. I pay for Fusion360 but when I had the free version it did an ok job of putting some rapids back in.

A post-processor for the Duet3 controller board with the Taig Mill: FlyFisher Post Processor

The best source of quick information about the Taig hardware is Carter's Tools. Some of his documentation is very good.

Unfortunately one of the best info sources is the Taig group on Facebook. If only it were a real forum instead of this.

Edit - History - Print - Recent Changes - Search
Page last modified on September 29, 2021, at 10:07 PM